STRUCTAflor® TERMIflor® is termite protected structural grade particleboard sheet flooring, providing cost-effective long-term defence against termite damage.
Produced to meet Australian/New Zealand Standard AS/NZS1860.1 Particleboard Flooring Part 1: Specifications and independently tested and accredited by The Engineered Wood Products Association of Australasia (EWPAA).
Formaldehyde emission meets the E1 standard requirement of ≤1.5 mg/L when tested in accordance with Australian/New Zealand Standard AS/NZS 4266.16:2004 Method of test 16: Formaldehyde emission - Desiccator method.
Environmental credentials are detailed in the Wood Solutions Environmental Product Declaration: Particleboard
Please refer to the STRUCTAflor® Installation and Design Manual
AS1860.2 Particleboard Flooring Part 2: Installation sets out the minimum performance requirements for the installation of particleboard flooring which are acceptable to building authorities in Australia.
Further information is also available in the EWPAA Particleboard Structural Flooring Design Manual
Design parameters information and safe load tables are included in the EWPAA Particleboard Structural Flooring Design Manual
The thermal conductivity of STRUCTAflor® is 0.12W/mK. Thermal resistance (R-values) calculated in accordance with the relevant provisions of Australian Standard AS/NZS4589.1 for the nominated thicknesses are:
STRUCTAflor® may be exposed to the weather for up to three months, however it is always advisable to enclose the building as soon as possible after laying the floor. Any ponded water should be removed as soon as practicable. This can be achieved by drilling holes of 3mm maximum diameter at not less than 1 metre spacing through the floor where ponding occurs and sweeping water away.
When storing outside ensure packs are kept clear of the ground. Cover with waterproof sheeting laid on timber battens so that air circulates freely between the waterproof cover and the product. Handle and stack with care to avoid damage.
Gloves, dust masks and glasses should be worn at all times when working with timber. Please refer to Material Safety Data Sheet (MSDS) for full details.
Off-cuts can be disposed of as normal landfill waste. Do not burn treated timbers. Please refer to above Material Safety Data Sheet (MSDS) for full details below.